Is it possible to use templates of our own or does it have to be the template that come with the software?
our own Meshes with unique UVs work too as template meshes 
did the staff confirm this?
since I haven´t had a statement of the staff,
I started the demo version used a unique full figure Template mesh which I edited before putting into Wrap and Wrap was able to handle it.*
- the only problem I had was with two fingers which were positioned so differently form the reference mesh, that wrap wasn´t able to recognize them- for that I had to edit the template mesh again and put it back into wrap.
the user case “unique template mesh + unique reference mesh” worked on my pc. compared to ZBrushes “project all”, wrap was able to handle more extreme differences between template and reference mesh.
hopefully that helps and you too can make a few tests with the available demo version
Hi,
hopefully mylissa doesn´t mind the hijacking of the topic.
I only used the Registration mode in the first case
setting points first on reference mesh → template mesh
the second case to fix the problems,
setting points first on template mesh → reference mesh
I haven´t tried on my test*.
- the differences where a lot higher than in the provided hand example which wrap is shipped with.
- I just wanted to quickly evaluate how Wrap handles more extreme cases with the least clicks possible
